If you want to set up a VPN on your router , then a firmware upgrade is pretty much a necessity in many cases also check out our guide to the best VPN for routers. However, DD-WRT is a powerful tool for those who have the know-how to use it or the patience to learn. Flashing your router is the term used for the process of loading a new firmware onto it. This process varies slightly from one model of router to another, but for the most part the general idea is the same.
Most firmware, DD-WRT included, needs to be designed specifically for the router it will operate on, or it will at the very least need to run on a router with nearly identical hardware. It covers all the most popular routers like Netgear and Asus models, as well as dozens of lesser-known routers from smaller companies. Before you flash your router, there are a few things we suggest you do. This helps prepare the router for the installation of the new firmware and prevents any kind of data corruption from happening during the setup.
How to do this step varies from one router to another, but it usually involves holding some kind of reset button on the back of the router. The lights on the front blinked, confirming that the RAM was cleared and we could move to the next step. In order for the transfer of the firmware from your computer to the router to be successful, you have to make sure the internet connection is using a static IP address.
We also found that disabling the WiFi on the router made the process work more reliably. For our router, we had to turn it off, then turn it back on while holding the reset button. Once you start flashing the DD-WRT firmware onto the router, the process should only take a couple of minutes if everything is working properly. This is the most typical use of gateway devices although they can also be employed to reduce network traffic.
An example of the gateway would be a device that joins Window NT network with a NetWare network or another one that connected a Personal Computer with a mainframe environment. The requirements of your network decide whether a router or a gateway would be more suitable for you. For example, let us assume that there are 30 computers in a single network that need to communicate with each other.
We have tried out best to explain in detail how a router and gateway works in the above article. The focus was to elaborate on their primary function and working principle to help decide which will suit better with your networking needs. In a nutshell, the gateway acts as a single point of access from one network to another just like a door.
In contrast, the router helps to determine the shortest possible path between two or more networks of the same type more like a staircase. All in all , both devices come with potential features that can enhance network connectivity. You just need to assess what your requirements are before choosing between DD-WRT router mode vs gateway mode. Save my name, email, and website in this browser for the next time I comment. Posted: Sun Nov 18, Post subject: Same questions. I was about to ask that question until I ran across this post.
I had the same problem too. Any suggestions??? Posted: Mon Nov 19, Post subject:. By any chance is your problem that the computers are not obtaining a IP address thru the guest ssid? Are all the dhcp request are handled through your gateway router? CognitiveSurplus wrote:. How to set up two dd-wrt Broadcom based routers to serve as Gateway and AP with dual, independent virtual lans for staff and guest usage including dual SSIDs staff and guest at each AP and the gateway.
Introduction: A staff only wireless and wired network is connected as a single lan, that allows normal connectivity and sharing. A separate guest wireless network allows connectivity to the Internet, but no connectivity to the staff network, nor to each other.
For my sanity the staff network is on While any non-routable network segments should work, the choice of separated address spaces made it easier to check and test the connectivity.
0コメント